Fields - fontFamily :: String
Font Family name, without subfamily classifiers such as Bold, Italic, etc... - fontVersion :: Int
Font version, multiplied by 1000, for example use 1500 for
version 1.5 - fontUnitsPerEm :: FWord
Number of units in an em-square. Should be a power of 2.
Typical values are 1024 or 2048. - fontEmBase :: FWord
Distance between the bottom of the em-square and the baseline
in font design units. - fontLineGap :: FWord
Linegap in font design units. Defined as distance between
baselines - height of em square (fontUnitsPerEm ). - fontWeight :: Weight
- fontWidth :: Width
- fontSlant :: Slant
Slant of the font. default: NoSlant - fontMonospaced :: Maybe Bool
fixed width font. default: False - fontLowestRecPPEM :: Maybe Int
Smallest readable size in pixels. default: 6 - fontItalicAngle :: Maybe Double
talic angle in counter-clockwise degrees from the
vertical. Zero for upright text, negative for text that leans to
the right (forward). default: 0 - fontCaretOffset :: Maybe FWord
The amount by which a slanted highlight on a glyph needs to be
shifted to produce the best appearance. default: 0 - fontSubScriptSize :: Maybe (FWord, FWord)
The recommended size in font design units for subscripts for
this font. default: (fontUnitsPerEM2, fontUnitsPerEM2) - fontSubScriptOffset :: Maybe (FWord, FWord)
The recommended offset in font design units for subscripts for
this font. default: (0, -fontUnitsPerEM/4) - fontSuperScriptSize :: Maybe (FWord, FWord)
The recommended size in font design units for superscripts for
this font. default: (fontUnitsPerEM2, fontUnitsPerEM2) - fontSuperScriptOffset :: Maybe (FWord, FWord)
The recommended offset in font design units for superscripts for
this font. default: (cos(90 + italicAngle)*snd superscriptYOffset, (fontUnitsPerEM-fontEmBase)/2) - fontEmbeddingLicence :: [EmbedLicence]
ndicates font embedding licensing rights for the
font. Embeddable fonts may be stored in a document. When a
document with embedded fonts is opened on a system that does not
have the font installed (the remote system), the embedded font
may be loaded for temporary (and in some cases, permanent) use on
that system by an embedding-aware application. Embedding
licensing rights are granted by the vendor of the font.
default: [] - fontStrikoutSize :: Maybe FWord
Width of the strikeout stroke in font design units. This field
should normally be the width of the em dash for the current
font. If the size is one, the strikeout line will be the line
represented by the strikeout position field. If the value is two,
the strikeout line will be the line represented by the strikeout
position and the line immediately above the strikeout
position. default: fontUnitsPerEm/20 - fontStrikeoutPosition :: Maybe FWord
The position of the top of the strikeout stroke relative to the
baseline in font design units. Positive values represent
distances above the baseline, while negative values represent
distances below the baseline. A value of zero falls directly on
the baseline, while a value of one falls one pel above the
baseline. The value of strikeout position should not interfere
with the recognition of standard characters, and therefore should
not line up with crossbars in the
font. default. fontUnitsPerEm/5.5 - fontFamilyClass :: Maybe (Int, Int)
The font class and font subclass are registered values assigned
by IBM to each font family. This parameter is intended for use in
selecting an alternate font when the requested font is not
available. The font class is the most general and the font
subclass is the most specific. The high byte of this field
contains the family class, while the low byte contains the family
subclass. See https://www.microsoft.com/typography/otspec/ibmfc.htm
for more information.
default: (0,0) - fontVendorID :: Maybe (Char, Char, Char, Char)
The four character identifier for the vendor of the given type
face. This is not the royalty owner of the original artwork. This
is the company responsible for the marketing and distribution of
the typeface that is being classified. It is reasonable to assume
that there will be 6 vendors of ITC Zapf Dingbats for use on
desktop platforms in the near future (if not already). It is also
likely that the vendors will have other inherent benefits in
their fonts (more kern pairs, unregularized data, hand hinted,
etc.). This identifier will allow for the correct vendor's type
to be used over another, possibly inferior, font file. The Vendor
ID value is not required.
default: (' ', ' ', ' ', ' ') - fontPanose :: Maybe (Int, Int, Int, Int, Int, Int, Int, Int, Int, Int)
Panose-1 Classification. default: (0, 0, 0, 0, 0, 0, 0, 0, 0, 0) - fontUnicodeRanges :: Maybe (Word32, Word32, Word32, Word32)
- :: Maybe (Word32, Word32)
- fontXHeight :: Maybe FWord
This metric specifies the distance between the baseline and the
approximate height of non-ascending lowercase letters measured in
FUnits. default height of glyph at U+0078 (LATIN SMALL LETTER
X) - fontCapHeight :: Maybe FWord
This metric specifies the distance between the baseline and the
approximate height of uppercase letters measured in FUnits.
default height of glyph at U+0048 (LATIN CAPITAL LETTER H). - fontLowerOpticalPointSize :: Maybe Int
This field is used for fonts with multiple optical styles. This value is the lower value of the size range for which this
font has been designed. The units for this field are TWIPs
(one-twentieth of a point, or 1440 per inch). The value is
inclusive—meaning that that font was designed to work best at
this point size through, but not including, the point size
indicated by usUpperOpticalPointSize. When used with other
optical fonts that set usLowerOpticalPointSize and
usUpperOpticalPointSize, it would be expected that another font
has this same value as this entry in the usUpperOpticalPointSize
field, unless this font is designed for the lowest size
range. The smallest font in an optical size set should set this
value to 0.When working across multiple optical fonts, there
should be no intentional gaps or overlaps in the
ranges. usLowerOpticalPointSize must be less than
usUpperOpticalPointSize. The maximum valid value is 0xFFFE.
default: 0 - fontUpperOpticalPointSize :: Maybe Int
fontUpperOptThis field is used for fonts with multiple optical styles. This value is the upper value of the size range for which this
font has been designed. The units for this field are TWIPs
(one-twentieth of a point, or 1440 per inch). The value is
exclusive—meaning that that font was designed to work best below
this point size down to the usLowerOpticalPointSize
threshold. When used with other optical fonts that set
usLowerOpticalPointSize and usUpperOpticalPointSize, it would be
expected that another font has this same value as this entry in
the usLowerOpticalPointSize field, unless this font is designed
for the highest size range. The largest font in an optical size
set should set this value to 0xFFFF, which is interpreted as
infinity. When working across multiple optical fonts, there
should be no intentional or overlaps left in the
ranges. usUpperOpticalPointSize must be greater than
usLowerOpticalPointSize. The minimum valid value for this field
is 2 (two). The largest possible inclusive point size represented
by this field is 3276.65 points, any higher values would be
represented as infinity. default: 0xffff - fontUnderlinePosition :: Maybe FWord
This is the suggested distance of the top of the underline from
the baseline (negative values indicate below baseline). The
PostScript definition of this FontInfo dictionary key (the y
coordinate of the center of the stroke) is not used for
historical reasons. The value of the PostScript key may be
calculated by subtracting half the underlineThickness from the
value of this field. default: default -fontUnitsPerEm/8 - fontUnderlineThickness :: Maybe FWord
suggested values for the underline thickness. default fontUnitsPerEm/10 - :: String
This field is used when the font has a subfamily other than
Weight, Width or Slant. Should not include any width, weight or
slant descriptions. default: "" - fontDecoration :: [Decoration]
Set if the font has any of these decorations. default: [] - fontCopyright :: String
Copyright notice. Default: [] - fontID :: String
- fontPsName :: String
postscriptName. default: full name with hyphen substituted for spaces. - fontTrademark :: String
- fontManufacturer :: String
Manufacturer Name. default: "" - fontDesigner :: String
name of the designer of the typeface. default: "" - fontLicence :: String
description of how the font may be legally used, or different
example scenarios for licensed use. This field should be written
in plain language, not legalese. default: "" - fontDescription :: String
description of the typeface. Can contain revision information,
usage recommendations, history, features, etc. - fontLicenceUrl :: String
URL where additional licensing information can be found.
default "" - fontDesignerUrl :: String
- fontVendorUrl :: String
URL of font vendor (with protocol, e.g., http://, ftp://). If a
unique serial number is embedded in the URL, it can be used to
register the font. - fontSampleText :: String
This can be the font name, or any other text that the designer
thinks is the best sample to display the font in. default: "" - fontLightPalette :: String
This ID, if used in the CPAL table’s Palette Labels Array,
specifies that the corresponding color palette in the CPAL table
is appropriate to use with the font when displaying it on a light
background such as white. Name table strings for this ID specify
the user interface strings associated with this
palette. default "" - fontDarkPalette :: String
Dark Backgound Palette. This ID, if used in the CPAL table’s
Palette Labels Array, specifies that the corresponding color
palette in the CPAL table is appropriate to use with the font
when displaying it on a dark background such as black. Name table
strings for this ID specify the user interface strings associated
with this palette - fontCreated :: UTCTime
- fontModified :: Maybe UTCTime
font modification time. default: creation time.
|